WaterBoss 900IF Owner's Manual download pdf (Page 14)

WaterBoss Filter Owner’s Manual 6/13/2012 14

Installation Steps and Start-Up Procedures, Cont.

Step 9

Complete the Installation

A. Connect the transformer power cord to the back of the controller.

B. Ensure that the appliance is in the Service position. See Figure 8.

C. Ensure the water supply is on.

D. Turn on the electricity and water supply to the water heater. For gas water heaters, return the

gas cock to “On.”

E. Open a cold water tap and allow the appliance to flush for 20 minutes or until approximately

72 gallons have passed through the appliance. This procedure is required to meet NSF

requirements. Verify the flow rate on the controller, which indicates water flow. See Figure 9.

F. Replace the cabinet cover.

Note: The next step is Start Up. Start-up procedures are provided for each of the following appliances:

 900IF Iron Filter

 900CF Carbon Filter

 900NF Acid Neutralizing Filter

Be sure to follow the Start-Up Procedure for your specific appliance.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

No comments

WaterBoss 900IF Owner's Manual Page 14