WaterBoss 900IF Specifications download pdf (Page 7)

Plug in the Transformer

A. Plug the transformer into an appropriate outlet. The transformer is 120 volt,

60 cycle ac for locations in the USA or 220 volt, 50 cycle ac for locations outside

the USA.

B. Ensure that the outlet selected is NOT operated by an on/off switch.

Program the Regeneration Cycle

To ensure reliable performance and optimum efficiency, program the regeneration cycle (backwash) to

occur every one to two days based on local conditions. On the controller, set the frequency and time of

day for regeneration to occur. Follow the instructions provided in

Setting the Controller

Start the Regeneration Cycle

Before placing the filter in service, backwash the filter to remove fine media particles in the filter bed.

To backwash the filter, start the regeneration cycle as follows:

A. Press and hold the REGENERATE button until the controller indicates 01 (flashing). The regenera-

tion cycle begins.

B. Regeneration is complete after seven minutes, and the appliance returns to service mode. The con-

troller will display a number between 01 to 02. This number is the days until the next regeneration.

Adjust Water Softener Hardness Setting

Typically, hardness will increase by two to four grains after passing through the neutralizing filter. If you

have a water softener, after implementing the start-up steps for the acid neutralizing filter

A. Test the hardness of the water before it enters the water softener.

B. Reset the hardness setting appropriately on the water softener.

Note

: The 900NF appliance requires periodic (annual) replenishment of the neutralizing media that

adjusts the pH level of the water. See

Replenishment Procedure

Important

The

aterBoss

900NF Neutralizing Filter is capable of elevating a low pH condition (acid) in your water. Install,

set up, and use the filter within the operating limits outlined in this manual. Failure to comply with these specifica-

tions may decrease the effectiveness of the backwash and cause control valve malfunction.

STEP 2

STEP 3

STEP 1

Start-Up Procedures

—

900NF Acid Neutralizing

Filter

STEP 4

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

WaterBoss 900IF Specifications Page 7