WaterBoss 900IF Owner's Manual download pdf (Page 17)

WaterBoss Owner’s Manual 9/2/2009 17

Advanced Customer Settings

Most customers will want to use the factory default settings, so no changes are necessary. However, you can

reset the controller settings if the factory default settings are not suitable for your needs.

Note: Be sure to check that the Time of Day is correct.

Set High Capacity or High Efficiency

Your appliance can be programmed for High Capacity (HC) or High Efficiency (HE).

• High Capacity means the appliance will regenerate less often, but use more salt.

• High Efficiency will make the appliance regenerate more often and use less salt. This is the default. The

High Efficiency setting meets or exceeds the requirement some states have for salt efficiency.

To Enter Advanced Customer Settings Mode

A. Press the Set and Change buttons for 3 seconds. The display should show only the controller type.

After 3 seconds, the entire screen is lit for a half second, and then “HC” displays.

B. Press Change to toggle the digit display between “HC” and “HE.”

C. When the desired value is displayed, press Set.

Note: HE ensures the appliance chooses salt settings that get 4,000 grains per pound (570 grams/kg)

of salt for each regeneration or better. This choice meets or exceeds the requirement some states

currently have in regards to salt efficiency.

Note: All models are equipped with patented capacity guard.

Once in HC or HE, you can set the mode, hours to next generation, gallons or liters, time format, time of day,

and time of regeneration.

Step 1

Set Mode

Display reads “Demand Mode.”

To Change Mode

A. Press Change.

− Delay Mode allows regeneration at a specific time (for example, at 2 a.m. when less

water is typically being used).

− Demand Mode triggers a regeneration as soon as softening capacity is exhausted. This

is the default.

B. When the desired mode is displayed, press Set.

Step 2

Set Hours Until Regeneration

Display reads “96 Hours.”

To Change Setting

A. Press Change to turn Off. If “96 Hours” is selected, the appliance will work no more than 4

days without a regeneration. Default is for “96 Hours” to be On.

Note: If there is iron in your water, select this option. If you are using model 950, on most

municipal water supplies, turn this option Off.

B. When the desired setting is displayed, press Set.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

No comments

WaterBoss 900IF Owner's Manual Page 17