WaterBoss 900IF Owner's Manual download pdf (Page 5)

WaterBoss Owner’s Manual 9/2/2009 5

Getting Maximum Efficiency From the Appliance

To achieve the maximum benefit and performance

from this appliance, familiarize yourself with this

manual and the appliance.

1. The salt level should always be at least 1/3 full.

Refill the salt when the level drops below the

water level in the brine cabinet. A resin cleaner

can be used on a monthly basis. A clean pellet,

solar, or cube-type salt is recommended. Do

not use rock salt.

Caution: Do not mix different types of salt.

2. You may switch to a salt substitute (such as

potassium chloride) in place of water

conditioner salt at any time. If potassium

chloride is used in place of salt, increase your

hardness setting by 12% (multiply by 1.12).

See Setting the Controller.

Caution: Do not use potassium chloride if there

is iron and/or manganese in the water.

3. Should your electricity be off for any reason

check your controller for the correct time and

reset as necessary (See Advanced Customer

Settings).

4. Program the appliance to regenerate at a time

when the water is not being used. If there is

more than one appliance, allow two hours

between each regeneration.

5. If dirt, sand, or large particles are present in the

water supply, the appropriate WaterBoss

filter

can eliminate this problem.

6. The appliance may be disinfected with 5.25%

sodium hypochlorite, which is the active

ingredient in household chlorine bleach. To

disinfect the appliance, add 4.0 fluid ounces of

chlorine bleach solution to the brine well of the

brine cabinet. The brine cabinet should have

water in it. Start a manual regeneration.

7. Protect the appliance, including the drain line,

from freezing.

8. The bypass valve (located on the main control

valve) enables you to bypass the appliance if

any work is being performed on the appliance,

well pump, or plumbing. See Bypass Valve.

Use Bypass mode also for watering plants or

lawns with untreated water.

9. Before putting the appliance back in service

after work has been performed, turn on the

nearest cold water tap until water runs clear.

10. Adhere to all operational, maintenance, and

placement requirements.

11. Inspect and clean the brine cabinet and air

check/draw tube assembly annually or when

sediment is present in the brine cabinet.

12. Potassium permanganate will need to be added

periodically to any iron filter.

13. Model 950 contains redox media and activated

carbon media. These have a finite life and will

eventually require replacement if the advertised

performance capabilities of this device are to

be maintained.

14. This product is certified for barium and radium

226/228 reduction according to NSF/ANSI

Standard 44. Any Bypass system must be

completely in the Service position to ensure

maximum barium and radium 226/228

reduction.

Efficiency Statements

This product is efficiency rated according to NSF/ANSI 44. The stated efficiencies are valid only at the specified

salt dosage and 8 gpm (30 L/m):

Model Rated Efficiency Salt Dosage Capacity at That Dosage

700 5,490 grains/lb (784 grams/kg) 1.1 lb (0.45 kg) 5,500 grains (356 grams)

900 5,600 grains/lb (798 grams/kg) 1.1 lb (0.45 kg) 5,600 grains (362 grams)

950 5,490 grains/lb (784 grams/kg) 1.6 lb (0.45 kg) 5,500 grains (356 grams)

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments

WaterBoss 900IF Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Water dispensers WaterBoss 900IF